Features • Design for indoor installation • Protections:Short circuit/Overload/Over voltage • Cooling by free air convection • 100% full load burn-in test • Optional dimming method:TRIAC or 0-10V dimmable • Suitable for LED lighting • Products passed CE, RoHS certification • 3 years warranty
- Product Description
DC output power
Ripple & Noise ( max) note.2
Voltage tolerance note. 3
Setup, Rise time note. 4
Hold up time( Typ. )
90-150VAC or 170-260VAC
AC current( Typ. )
Cold start ≤ 50A
Incoming line stability
Power factor( Typ. )
Efficiency ( Typ. )
The power supply can resume normal operation when the short circuit is removed during power supply.
105%-150% rated output power.
Protection type: Hiccup mode, recovers automatically after fault condition is removed.
After the over current fault is removed, the power supply will automatically resume normal operation.
Ambient Temperature 70℃ ± 10%
Protection mode; the product is hiccup state, protect the product from damage, when the fault is ruled out, the power supply is normal.
-10℃ ~ +55℃( Refer to“derating curve”)
20% ~90%RH non-condensing
-40℃ ~ +85℃， 10% ~95%RH
10-500Hz, 2G 10min. / 1 cycle, 60 min. each axes
Input voltage : 220V 50HZ Rated output current 25℃ , Burn-in 2h
Input and output: 1.5KVAC 5mA 3s input and shell; 1.5KVAC 5mA 3s
Between input and output, input and shell: 500VDC / 100MΩ
Compliance to EN55032(CISPR32)Class B.EN61000-3-2,-3,EAC TP TC 020
Compliance to EN61000-4-188.8.131.52.6.8.11.EN55024,lightindustry level,criteria A,EAC TP TC 020
UL62368-1,TUV EN62368-1.EAC TP TCO04 approved
All parameters NOT specially mentioned are measured at 230VAC input,rated load and 25℃ of ambient temperature.
Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf &47uf parallel capacitor.
Tolerance: includes set up tolerance. Line regulation and load regulation.
Length of set up time is measured at first cold start .Turning ON/ OFF the power supply may lead to increase of the set up time.
1. Adjustable photo electron driver; one dimmer can drive multiple power supplies;and the numbers aredecided by the dimmer maximum load capacity. The positive and negative of dimmer should be connected topositive and negative of the power supply’ s dimming.Terminals,Regulating the dimmer will produce a kindof 0-10V signal to power supply, then changing the luminous flux of the lamp.
2.Regulations Dimming operation Tandem triac dimmer before input terminals AC,then adjust the outputconstant current value.
Notice:the output of the 0-10V adjustable photo electron driver that dimming interface of the power supplysupply connected should be a stable 0-10V DC voltage.
- Guangdong Dingying Lighting